Inventor General Discussion

Reply
Active Contributor
smjanows
Posts: 39
Registered: ‎04-03-2012
Message 1 of 2 (1,363 Views)

Missing iMate Glyphs

1363 Views, 1 Replies
01-25-2013 09:59 AM

I'm running IV2012 Pro SP2 and in some assemblies, the iMates of subassemblies do not show up.  I've tried all permutation od iMate glyph visibility to no avail.  If I drop the same subassembly into a new assembly, the iMates are available.  How do I get them back on?  I'm not about to recreate the assembly (It's an iAssembly), so that is not an option.  Am I stuck manually constraining my fastener subassemblies?  Other parts in the assembly have their iMates show up fine.

 

 

Fullscreen capture 1252013 115811 AM.bmp.jpg

iMates on flange fine.

 

Fullscreen capture 1252013 115808 AM.bmp.jpg

iMates on fasteners missing.  Show up fine in other assemblies.

Active Contributor
smjanows
Posts: 39
Registered: ‎04-03-2012
Message 2 of 2 (1,360 Views)

Re: Missing iMate Glyphs

01-25-2013 10:07 AM in reply to: smjanows

Alright, this must be a bug.  It turns out the iMates were already consumed.  But the fastener assembly was free to be dragged around until I put in contraints.  After deleting the iMate contraint it's back.  This is very odd behvaior.  No red + sign indicating that anything was wrong.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.