Inventor General Discussion

Reply
*Beissel, Josh
Message 1 of 3 (63 Views)

Migration question??

63 Views, 2 Replies
11-17-2002 11:51 PM
I just reloaded IV6 w/SP1, and everything works great so far. Just wanted to
know if I need to migrate any of my drawings that are pre IV5.3 into IV5.3
before I start to migrate into IV6, or can I just take them straight to IV6
without any problems? All files are stored on a server & backed up so if
there are problems I can still retrieve anything that might get lost.
Thanks for any help you can give me. Josh
Distinguished Contributor
jmartzig
Posts: 609
Registered: ‎12-01-2003
Message 2 of 3 (63 Views)

Re: Migration question??

11-18-2002 05:09 AM in reply to: *Beissel, Josh
i believe somewhere in the migration it says if the files are pre-5.3, then you should do a "rebuild all" in the migrate. -Joe
*Beissel, Josh
Message 3 of 3 (63 Views)

Re:

11-18-2002 05:51 AM in reply to: *Beissel, Josh
O.K. I'll check that out & try it. 
Thanks


style="BORDER-LEFT: #000000 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px; PADDING-RIGHT: 0px">
believe
somewhere in the migration it says if the files are pre-5.3, then you should
do a "rebuild all" in the migrate. -Joe
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.