Inventor General Discussion

Inventor General Discussion

Reply
Contributor
JavZaMa
Posts: 18
Registered: ‎05-07-2012
Message 1 of 5 (153 Views)

Migrating from Inventor 2011 to Inventor 2010

153 Views, 4 Replies
09-04-2012 11:40 AM

Hi, I have generated a mold assembly on Inventor 2011, but I have to migrate these files to Inventor 2010, because is the version I use in my job, IT manager uninstalled Inventor 2010 and installed 2011 version, I worked on it but then back to work on 2010 version. Is there a way to do it?

*Pro
jletcher
Posts: 1,983
Registered: ‎05-18-2011
Message 2 of 5 (149 Views)

Re: Migrating from Inventor 2011 to Inventor 2010

09-04-2012 11:43 AM in reply to: JavZaMa

no..

 

Step file is the only way to go backwards..........


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
Contributor
JavZaMa
Posts: 18
Registered: ‎05-07-2012
Message 3 of 5 (141 Views)

Re: Migrating from Inventor 2011 to Inventor 2010

09-04-2012 11:50 AM in reply to: jletcher

ok :smileysad:
Do I have to do it with the Content Center Files too???

*Pro
jletcher
Posts: 1,983
Registered: ‎05-18-2011
Message 4 of 5 (138 Views)

Re: Migrating from Inventor 2011 to Inventor 2010

09-04-2012 11:54 AM in reply to: JavZaMa

I do not know if they was made with 2011 and saved but I do know that CC parts are not migrated through autodesk. So some of the CC files are in 2008 format.. You may get lucky :smileyhappy:


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
*Expert Elite*
jclaidler
Posts: 581
Registered: ‎10-29-2009
Message 5 of 5 (103 Views)

Re: Migrating from Inventor 2011 to Inventor 2010

09-05-2012 06:29 AM in reply to: JavZaMa

Content Center files are 'ipt' files, and also are not 'backward compatible'. 

John Laidler

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.