Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
gordon.rogers
Posts: 31
Registered: ‎10-11-2011
Message 1 of 2 (349 Views)
Accepted Solution

Mass properties will not display in text box.

349 Views, 1 Replies
07-09-2012 02:06 PM

I'm having trouble getting mass properties of an assembly to display in an .idw.  I've tried it 2 diffent ways, custom properties-model "Totalmass" where I type the mass and physical properties-model "mass" where it's automatic with update.. Nothing shows, not even N/A, but in another idw (different assembly) it works. Both text boxes are saved within a sketch that is part of a template. Both idw's use the same template. If I place text on the drawing it self it works. Any suggestions would be great before I pull all my hair out.

 

Thanks

 

IV 2012

Vault Collaboration 2012

the sketch has to be associated with a view to pick up the model data.

if the sketch is simply on the sheet, you will only be able to reference drawing properties

Valued Mentor
Rich.O.3d
Posts: 526
Registered: ‎08-19-2008
Message 2 of 2 (343 Views)

Re: Mass properties will not display in text box.

07-09-2012 03:12 PM in reply to: gordon.rogers

the sketch has to be associated with a view to pick up the model data.

if the sketch is simply on the sheet, you will only be able to reference drawing properties

CAD Management 101:
You can do it your own way,
If its done just how I say!
[Metallica:And Justice For All:1988]
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.