Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
es12
Posts: 88
Registered: ‎08-28-2009
Message 1 of 5 (252 Views)
Accepted Solution

Making tube between two circles

252 Views, 4 Replies
10-28-2011 11:05 PM

I've been trying to make tube between these circles but I can't figure it out how to make it smooth. I tried sweep too but that didn't work too well. Here's picture of my try without sweep: http://i.imgur.com/xvGyZ.jpg

 

You see that it leaves corners on the back. I would like to have it so it's smooth and has same angle. How should I do it?

Something like this?

Distinguished Contributor
rajeshindi
Posts: 141
Registered: ‎12-07-2009
Message 2 of 5 (241 Views)

Re: Making tube between two circles

10-29-2011 04:11 AM in reply to: es12

How about this?

*Expert Elite*
JDMather
Posts: 27,456
Registered: ‎04-20-2006
Message 3 of 5 (235 Views)

Re: Making tube between two circles

10-29-2011 05:28 AM in reply to: es12

Something like this?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Valued Contributor
es12
Posts: 88
Registered: ‎08-28-2009
Message 4 of 5 (221 Views)

Re: Making tube between two circles

10-29-2011 09:07 AM in reply to: JDMather

Thank you both! JDMather for teaching me how to sweep and rajeshindi for teaching alternative way :smileyhappy:

New Member
Echoo
Posts: 1
Registered: ‎10-29-2011
Message 5 of 5 (217 Views)

Re: Making tube between two circles

10-29-2011 09:28 AM in reply to: JDMather

i think thats better ...i'he ever use this way to make a pipe part ..

nice greeting i'm the new at this forum

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.