I was asked to make a 3-D version of a eyenut that we are going to build. The difficulty that I'm having is that the loop is two different diameters. Where it connects to the threaded portion it's dia. is 1.75, and when it arcs to the top the diameter increases to 2.750 inches. Any suggestions on how to do this would be great. (I'm not sure how sensitive this information will be so I'm trying to give enough info without giving anything away)
With the shape changing, one would have to use the Loft with a starting profile, the required profile at mid point and a ending profile.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!