Inventor General Discussion

Inventor General Discussion

Reply
New Member
simons.jason
Posts: 2
Registered: ‎01-23-2012
Message 1 of 3 (139 Views)

Making a flat projection from a loft

139 Views, 2 Replies
05-01-2012 11:57 AM

Hi,

 

Please excuse the fact that this may be more simple than I am making it, but I have been working with inventor for a couple months. I am still getting the hang of it.

 

Anyhow, I made this part, which is a loft consisting of five symetric squares. I plan on laser cutting each side, which would be exactly the same. 

 

I can't seem to figure out how to make a flat projection of one of the sides. I have tried in sheet metal, but I don't use that feature in my line of work. 

 

Any help would be appreciated!

 

Thanks,

 

Jason

Employee
johnsonshiue
Posts: 2,345
Registered: ‎04-30-2008
Message 2 of 3 (130 Views)

Re: Making a flat projection from a loft

05-01-2012 01:06 PM in reply to: simons.jason

Hi! Inventor is capable of unfolding certain spline geometry. Unfortunately, the one you created using Loft is not supported, while Lofted Flange only supports two sections.

There might be other ways to do it but I have found a way to create the desirable geometry with relatively few features. Please take a look at attached part. Let me know if you have any question.

Thanks!

 



Johnson Shiue (johnson.shiue@autodesk.com)
Senior Principal SQA Engineer, Inventor
Mechanical Design
Autodesk, Inc.

New Member
simons.jason
Posts: 2
Registered: ‎01-23-2012
Message 3 of 3 (128 Views)

Re: Making a flat projection from a loft

05-01-2012 01:23 PM in reply to: johnsonshiue

Thanks, That is exactly what I was looking for!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.