Inventor General Discussion

Inventor General Discussion

Distinguished Contributor
Posts: 164
Registered: ‎10-10-2007
Message 1 of 1 (83 Views)

Lost adaptivity during modification of a tube and pipe run

83 Views, 0 Replies
02-01-2013 02:08 PM

What would cause a tube run to lose adaptivity. Was trying to add a part to define an area to constrain the tube route to, and after editing the tube run was no longer adaptive 

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.