Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
IV 7....I cannot get loft w. rails to work. I have a cylinder with a rectangular rib of varying thickness traversining about the radius. I created a rail on each of the verticies by projecting workpoints as the forum suggests. The model is fully constrained. What am I missing?
Would you consider posting the model so we may take a look?
Thanks in advance,
--
Best regards.
Hugh Henderson (SQA Engineer) wrote in message news:4814197@discussion.autodesk.com...
> IV 7....I cannot get loft w. rails to work. I have a cylinder with a
rectangular rib of varying thickness traversining about the radius. I
created a rail on each of the verticies by projecting workpoints as the
forum suggests. The model is fully constrained. What am I missing?
I finally got it...whew, a lot of work creating/projecting workpoints, planes, rails, etc. But I could find no way to do this in MDT. Possible in IV with an appropriate amount of patience.
MDT loft does not have loft with rails. wrote in message news:4814436@discussion.autodesk.com...
>I finally got it...whew, a lot of work creating/projecting workpoints,
>planes, rails, etc. But I could find no way to do this in MDT. Possible
>in IV with an appropriate amount of patience.
MDT had me goin for well over a minute! I built the part using surfacing, UV this and that, came up with an awful wireframe mess in a non-parametric solution. So now I am finally forced to learn Inventor, MDT diehard I am.
Your not trying to get into the marketing dept. are you???
Ed
"Shekar Subrahmanyam[Autodesk]" wrote in
message news:4815226@discussion.autodesk.com...
> Sure:). Make that a few minutes....... MDT is not as easy to use as
> Inventor.
>
>
>> 8~) Had you goin' for a minute there, though, didn't I?
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")