Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Did you toggle the output to "surface"? If these are open profiles,
instead of closed shapes, that should do it.
darvin
"captbob" wrote in message
news:f19b0d6.-1@WebX.maYIadrTaRb...
> The loft command is very finecky (sp?)
> I have scketched 4 different "C" shaped lines on different working
planes, they are located in a row so they should loft easily.
>
> Inventor won't let me pick any of the sketch's, whats the secret ??
>
> Thanks
> Bob
>
The loft inferface is a bit goofy. If you toggle solid to surface you'll have
to go back to Sections and click on "Click to add" before you can pick a
section.
There are a few other stumbling blocks. Might look for another lofting post
from yesterday that covered some of them.
All else fails, post the file to ivCF and someone will probably be willing to
give it a whirl.
=================================
"captbob" wrote in message
news:f19b0d6.1@WebX.maYIadrTaRb...
> I tried the surface, it won't even let me pick one curve.
>
lol
I forgot about that one. Then you have to go up and re-activate the
profile selection box before you can pick again. There are so many of
those "reset idiosyncrasies" in the dialogs they just become part of
SOP. My carpel tunnels inflame just thinking about it.
darvin
"Jeff Howard" wrote in message
news:188D6D3F901FCCD7E04820E2876966CB@in.WebX.maYIadrTaRb...
> The loft inferface is a bit goofy. If you toggle solid to surface
you'll have
> to go back to Sections and click on "Click to add" before you can pick
a
> section.
>
> There are a few other stumbling blocks. Might look for another
lofting post
> from yesterday that covered some of them.
>
> All else fails, post the file to ivCF and someone will probably be
willing to
> give it a whirl.
>
> =================================
> "captbob" wrote in message
> news:f19b0d6.1@WebX.maYIadrTaRb...
> > I tried the surface, it won't even let me pick one curve.
> >
>
>
They loft fine here. Just hit the loft button > toggle to surface > the
click on the "click here to add" line in the profiles are. Not sure if
it makes a differenc, but I picked the one on the vissible workplane
1st. The walked back from right to left.
darvin
"captbob" wrote in message
news:f19b0d6.1@WebX.maYIadrTaRb...
> I tried the surface, it won't even let me pick one curve.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")