Inventor General Discussion

Reply
New Member
SPGMATT
Posts: 2
Registered: ‎01-20-2013
Message 1 of 5 (424 Views)
Accepted Solution

Loft Advice

424 Views, 4 Replies
01-20-2013 08:06 AM

Im struggling coming up with a loft or sweep to get the design effect I need. Please see on the pic how the profile terminates to a point. Any help or advice would be appreciated

Just a real quick 5 minute attempt, but you can get some ideas from it.

newell.jpg

Mentor
BarryZA
Posts: 181
Registered: ‎08-27-2012
Message 2 of 5 (324 Views)

Re: Loft Advice

01-21-2013 06:09 AM in reply to: SPGMATT

I am a beginner myself, and I am sure someone will come along and give you proper advice, but I'll give it a bash later on.

 

I'll try a 3d sketch intersect to create the lifted bit, and maybe use split to try to loft bit by bit around that tight corner.

 

Cheers

*Expert Elite*
blair
Posts: 4,195
Registered: ‎11-13-2006
Message 3 of 5 (287 Views)

Re: Loft Advice

01-21-2013 08:33 AM in reply to: SPGMATT

Create your round end first, most likely a Revolve to form the end Button. Then create your Sweep from this. You should be able to copy the outer edge of the Button onto the sketch for the profile of the Sweep

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Delta Tau Chi ΔΤΧ
Valued Mentor
mpatchus
Posts: 480
Registered: ‎10-22-2008
Message 4 of 5 (248 Views)

Re: Loft Advice

01-21-2013 11:51 AM in reply to: SPGMATT

Just a real quick 5 minute attempt, but you can get some ideas from it.

newell.jpg

Mike Patchus

Inventor 2012 SP3 ~ Vault Pro 2013
==================
Lenovo D20 Workstation Intel Xenon E5640@2.67GHz (2)
Win 7, 24gb RAM, NVIDIA Quadro FX 3800

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below. :smileyhappy:
New Member
SPGMATT
Posts: 2
Registered: ‎01-20-2013
Message 5 of 5 (186 Views)

Re: Loft Advice

01-23-2013 02:49 PM in reply to: mpatchus

Thanks for your help Mike, I got it  

 

Steve

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.