Inventor General Discussion

Inventor General Discussion

Posts: 24
Registered: ‎07-10-2009
Message 1 of 3 (191 Views)
Accepted Solution

Line visibility in IDW

191 Views, 2 Replies
01-09-2013 11:17 AM

Using Inventor 2013.  In an IDW, I have toddled off visibility of lines in a view.  I would like to regain visibility of these lines.  HOW?

*Expert Elite*
Posts: 2,881
Registered: ‎03-08-2006
Message 2 of 3 (190 Views)

Re: Line visibility in IDW

01-09-2013 11:21 AM in reply to: messt14

Hi messt14,


Here's a link with some screen shots that provide the answer to your question:


I hope this helps.
Best of luck to you in all of your Inventor pursuits,

  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.

*Expert Elite*
Posts: 3,243
Registered: ‎12-07-2011
Message 3 of 3 (187 Views)

Re: Line visibility in IDW

01-09-2013 11:29 AM in reply to: messt14

If you RC on the view with the lines that have the visibility turned off you will see this selection.


Then select the lines you want to bring back and RC again and select "Done".

Best Regards,
Scott McFadden
Inventor Professional 2013
(Colossians 3:23-25)

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.