Inventor General Discussion

Reply
Contributor
messt14
Posts: 24
Registered: ‎07-10-2009
Message 1 of 3 (201 Views)
Accepted Solution

Line visibility in IDW

201 Views, 2 Replies
01-09-2013 11:17 AM

Using Inventor 2013.  In an IDW, I have toddled off visibility of lines in a view.  I would like to regain visibility of these lines.  HOW?

Hi messt14,

 

Here's a link with some screen shots that provide the answer to your question:

http://forums.autodesk.com/t5/Autodesk-Inventor/Turning-on-Visibility-of-Line-Segments-in-Drawings/m-p/3641556#M449721

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

*Expert Elite*
Curtis_Waguespack
Posts: 2,950
Registered: ‎03-08-2006
Message 2 of 3 (200 Views)

Re: Line visibility in IDW

01-09-2013 11:21 AM in reply to: messt14

Hi messt14,

 

Here's a link with some screen shots that provide the answer to your question:

http://forums.autodesk.com/t5/Autodesk-Inventor/Turning-on-Visibility-of-Line-Segments-in-Drawings/m...

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





*Expert Elite*
Cadmanto
Posts: 3,320
Registered: ‎12-07-2011
Message 3 of 3 (197 Views)

Re: Line visibility in IDW

01-09-2013 11:29 AM in reply to: messt14

If you RC on the view with the lines that have the visibility turned off you will see this selection.

HIDDEN.PNG

Then select the lines you want to bring back and RC again and select "Done".

Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.