Inventor General Discussion

Inventor General Discussion

Reply
Contributor
wth_187
Posts: 11
Registered: ‎11-10-2012
Message 1 of 1 (71 Views)

Limits and Regions in Parameter Definition

71 Views, 0 Replies
11-18-2012 08:06 AM

For my current project I need to define relative part motion using parameters-- however, I want the equation defining motion to change mid-revolution.

 

For example, say I have to wheels, A and B, with rotational angles of ThetaA and ThetaB respectively. I might want wheel A to rotate 2*BTheta degrees for rotational angles of B between 0 and 180 degrees (so ThetaA = 2*ThetaB), but rotate only at ThetaA = ThetaB for angles between 180 and 360 degrees.

 

That's simplified, but essentially my problem. How do I make parameters within regions?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.