Inventor General Discussion

Inventor General Discussion

Reply
Contributor
vinzs78
Posts: 18
Registered: ‎02-01-2012
Message 1 of 3 (260 Views)
Accepted Solution

Learning: creating a wood panel

260 Views, 2 Replies
02-01-2012 06:47 PM

 

 

Hi guys,

I have just started to learn how to use Inventor.... I am loving this software so far but finding difficult to learn on my own.

 

I am trying to create a rectangle panel wood with sides with different angles (700x1000mm and thick of 15mm) 2 sides need to be 45degres and the 2 other 25degres.

 

I have tried withh the Extrude and taper function ...but this doesn t let me create different angles(taper) on each sides. 

 

What would be the best way to do this? What other function could i use?

 

I hope i was clear enought!

 

Thanks in advance

extrude your profile with square sides, then use the Chamfer command. You could also create a sketch on the side of panel, produce a triangle of the shape of the material you wish to remove and use the extrude command, but with the "cut" option.

*Expert Elite*
blair
Posts: 4,467
Registered: ‎11-13-2006
Message 2 of 3 (256 Views)

Re: Learning: creating a wood panel

02-01-2012 08:08 PM in reply to: vinzs78

extrude your profile with square sides, then use the Chamfer command. You could also create a sketch on the side of panel, produce a triangle of the shape of the material you wish to remove and use the extrude command, but with the "cut" option.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / 17.2.0.11011 / 4.17
Delta Tau Chi ΔΤΧ
Contributor
vinzs78
Posts: 18
Registered: ‎02-01-2012
Message 3 of 3 (221 Views)

Re: Learning: creating a wood panel

02-02-2012 08:30 PM in reply to: blair

Super! thanks Blair....i learned how to use the Chamber command...It is exactly what i need! thanks for the help

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.