Whoops - spoke too soon - still warns me that my graphics driver is not
certified, even though it is. I'll uncheck those boxes again.
Have a nice weekend!
"Keith Bender" wrote in message
news:FE0C4C1B0A7814C86A8E62CB41A97B01@in.WebX.maYIadrTaRb...
> What a nice installation experience I had. I began downloading the file
at
> 5:15PM, and finished installing the SP by 5:45PM. It took only 2 min
20secs
> to download on T1 line. I read the readme, re-booted my PC, doubleclicked
> on the file, and everything else was done for me (I did have to insert my
> Inventor 6 CD). I re-booted again, started Inventor, checked the
Help>About,
> and everything checked out. I changed my Options to warn me about
graphics
> driver options, and then loaded an IDW which performed well. I loaded a
> large assembly, spun it, zoomed it, added a few nuts from the content
> library, constrained them with the insert constraint, spun it till it was
> dizzy (or was that me?).
>
> Two problems I had previously didn't show up - the graphics driver
warnings,
> and slowwww constraint application.
>
> IT LOOKS GOOD SO FAR!
>
> Nice job Autodesk - thank you.
>
> It is past time to go home - I'll report back next week.
>
> Good luck to all of you with this installation.
>
> Keith
>
>
>