Inventor General Discussion

Inventor General Discussion

Reply
*Myers, Kim
Message 1 of 4 (16 Views)

IV6 Sketch Dimension Error

16 Views, 3 Replies
12-09-2002 12:05 AM
Please take a look at the file under the same topic in CF. The value of my
sketch dimension is not correct in regards to the actual value. I have no
idea how this happened. Has anyone else seen this?
Distinguished Contributor
jmartzig
Posts: 609
Registered: ‎12-01-2003
Message 2 of 4 (16 Views)

Re: IV6 Sketch Dimension Error

12-09-2002 12:24 AM in reply to: *Myers, Kim
i haven't looked at your post, but today in idw mode, i got a dimension that was 2.13". i knew that wasn't correct. exited the idw, opened it again, and dimmed again. it then gave me the correct dimension of 7.36". go figure? -Joe
*Myers, Kim
Message 3 of 4 (16 Views)

Re:

12-09-2002 12:52 AM in reply to: *Myers, Kim
This was in a .ipt, but yours is just as bad if not
worse.  The guys in the shop just love to hear it when we blame our
mistakes on the software.  The problem is they think it is just an
excuse.


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
haven't
looked at your post, but today in idw mode, i got a dimension that was 2.13".
i knew that wasn't correct. exited the idw, opened it again, and dimmed again.
it then gave me the correct dimension of 7.36". go figure?
-Joe
*Myers, Kim
Message 4 of 4 (16 Views)

Re:

12-10-2002 05:23 AM in reply to: *Myers, Kim
Anyone have any thoughts on this?


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">

This was in a .ipt, but yours is just as bad if
not worse.  The guys in the shop just love to hear it when we blame our
mistakes on the software.  The problem is they think it is just an
excuse.


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
haven't
looked at your post, but today in idw mode, i got a dimension that was
2.13". i knew that wasn't correct. exited the idw, opened it again, and
dimmed again. it then gave me the correct dimension of 7.36". go figure?
-Joe
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!