IV2014 Constrain Cylinder Axis to Multipart Slot Centerline

[hfds006]

In the attached image I have the blue pin constrained to the straight slot and it's travel is restricted to the length of the slot.

The red pin fits into the two part slot.

Is it possible to constrain the axis of the red pin to the centerline of the two part slot?

[CCarreiras]

Hi!

You can use a transitional constrain to achieve that.

First in the Yellow part copy the 3 lateral slot walls as a surface. Then you can use this surface and the cilinder wall to constrain.

Did you find this reply helpful ? If so, use the    Accept as Solution or Kudos - Thank you!

[CCarreiras · Accepted solution]

Hi!

Check the video in attach..

Did you find this reply helpful ? If so, use the    Accept as Solution or Kudos - Thank you!

[hfds006]

Thanks, that's exactly what I needed.