Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
^_^clovis^_^
Posts: 33
Registered: ‎11-16-2010
Message 1 of 6 (133 Views)

IV 2013 coil weight error

133 Views, 5 Replies
11-27-2013 03:33 AM

Hello all,

Using Inventor 2013 SP1

A user just point out to me that when making a coil with 12 revolution is OK but 13 is really wrong.

tube Ø54x2 mm

Øcoil = 800 mm

pitch = 55 mm

Is there a patch for that?

Thanks

Distinguished Mentor
ccarreiras
Posts: 974
Registered: ‎02-04-2010
Message 2 of 6 (125 Views)

Re: IV 2013 coil weight error

11-27-2013 04:11 AM in reply to: ^_^clovis^_^

Hi!

 

Really wrong why? Install all the service Packs available.

 

My System:

2.png

 

My Result:2.png

 

Did you find this reply helpful ? If so, use the  Mark Solutions!  Accept as Solution or Give Kudos!Kudos - Thank you!

Regards.
CarlosC

Autodesk Inventor 2014 Certified Professional
Autodesk Factory Design Suite Ultimate 2015
Windows 7 64Bit
Active Contributor
^_^clovis^_^
Posts: 33
Registered: ‎11-16-2010
Message 3 of 6 (117 Views)

Re: IV 2013 coil weight error

11-27-2013 04:31 AM in reply to: ccarreiras

Hello, with

12 revolutions -> 155.7 kg

13 revolutions -> 84.3 kg ??

 

Actually I have SP2 with Inventor 2013

 

Thanks for any advice

Product Support
bob.holland
Posts: 409
Registered: ‎02-15-2013
Message 4 of 6 (94 Views)

Re: IV 2013 coil weight error

11-27-2013 10:07 AM in reply to: ^_^clovis^_^

Clovis,

 

Thank you for pointing this out.

It seems that 12 has the issue.

10, 11 and 13 seem to progress as expected.

It also looks like that material does not make a difference either.

 

I will be providing this to our developers to address.

 

Thank you again and have a wonderful Thanksgiving.



Bob Holland


Product Support
bob.holland
Posts: 409
Registered: ‎02-15-2013
Message 5 of 6 (92 Views)

Re: IV 2013 coil weight error

11-27-2013 10:19 AM in reply to: ^_^clovis^_^

I wanted to let you know that I tested it in 2014 and it has been resolved.

 

FYI



Bob Holland


Active Contributor
^_^clovis^_^
Posts: 33
Registered: ‎11-16-2010
Message 6 of 6 (71 Views)

Re: IV 2013 coil weight error

11-28-2013 02:52 AM in reply to: bob.holland

I suspect that we'll update to IV2014 next year so I'll drop the remark.

Thanks

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.