Inventor General Discussion

Inventor General Discussion

Reply
Active Member
harris.1782
Posts: 6
Registered: ‎07-09-2012
Message 1 of 2 (148 Views)
Accepted Solution

Issue with 2010 Inventor

148 Views, 1 Replies
07-09-2012 08:25 AM

when a rectangle is drawn with dimensions 44 wide by 79 height in inches it becomes a slanted rectangle. Other versions of Inventor I have used don't do that is there a way to fix it?

*Expert Elite*
Curtis_Waguespack
Posts: 2,879
Registered: ‎03-08-2006
Message 2 of 2 (143 Views)

Re: Issue with 2010 Inventor

07-09-2012 08:41 AM in reply to: harris.1782

Hi harris.1782,

 

You've likely toggled off your Constraint Inference and/or Constraint Persistence buttons.

 

Autodesk Inventor Constraint Inference and Persistence.png

 

This link from Paul Munford covers these tools and how they work:

http://cadsetterout.com/inventor/temporarily-turn-off-inferred-constraints/

 

 

Or you've turned off the inference for just some of the constraints.

Check this by right-clicking while in a sketch and choosing Constraint Options:

 

 

 

I hope this helps.

Good luck with all of your Inventor pursuits,

Curtis

http://inventortrenches.blogspot.com/



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.