Inventor General Discussion

Inventor General Discussion

Reply
Active Member
harris.1782
Posts: 6
Registered: ‎07-09-2012
Message 1 of 2 (149 Views)
Accepted Solution

Issue with 2010 Inventor

149 Views, 1 Replies
07-09-2012 08:25 AM

when a rectangle is drawn with dimensions 44 wide by 79 height in inches it becomes a slanted rectangle. Other versions of Inventor I have used don't do that is there a way to fix it?

Hi harris.1782,

 

You've likely toggled off your Constraint Inference and/or Constraint Persistence buttons.

 

Autodesk Inventor Constraint Inference and Persistence.png

 

This link from Paul Munford covers these tools and how they work:

http://cadsetterout.com/inventor/temporarily-turn-off-inferred-constraints/

 

 

Or you've turned off the inference for just some of the constraints.

Check this by right-clicking while in a sketch and choosing Constraint Options:

 

 

 

I hope this helps.

Good luck with all of your Inventor pursuits,

Curtis

http://inventortrenches.blogspot.com/

*Expert Elite*
Curtis_Waguespack
Posts: 2,986
Registered: ‎03-08-2006
Message 2 of 2 (144 Views)

Re: Issue with 2010 Inventor

07-09-2012 08:41 AM in reply to: harris.1782

Hi harris.1782,

 

You've likely toggled off your Constraint Inference and/or Constraint Persistence buttons.

 

Autodesk Inventor Constraint Inference and Persistence.png

 

This link from Paul Munford covers these tools and how they work:

http://cadsetterout.com/inventor/temporarily-turn-off-inferred-constraints/

 

 

Or you've turned off the inference for just some of the constraints.

Check this by right-clicking while in a sketch and choosing Constraint Options:

 

 

 

I hope this helps.

Good luck with all of your Inventor pursuits,

Curtis

http://inventortrenches.blogspot.com/



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Post to the Community

Have questions about Autodesk products? Ask the community.

New Post