Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
Curtis_Waguespack
Posts: 2,963
Registered: ‎03-08-2006
Message 11 of 12 (114 Views)

Re: Isometric Shaft Dimension

04-20-2012 09:18 AM in reply to: cbenner

Hi cbenner,

 

You can set a linear dimension to use the sheet plane, but it won't calculate correctly. But it might work if you overide the value and place notes instead. Or you might be able to place a linear dimension and hide an arrowhead, exension line, etc. to make it look like a leader. But I don't know of a way to get a leader note to park on a model plane.

 

I suppose you could cheat and place some small circular phantom part in your assembly to use for placement of a diameter dimension and then overide it to use as a leader note. :smileyfrustrated:

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com




  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





*Expert Elite*
cbenner
Posts: 3,334
Registered: ‎04-06-2010
Message 12 of 12 (109 Views)

Re: Isometric Shaft Dimension

04-20-2012 09:48 AM in reply to: Curtis_Waguespack

Thanks Curtis.

 

Thankfully this is an oddball drawing, and we don't normally do this.  I recall back in the horse & buggy days having to create special text styles in AutoCad to do this on isometric drawings for a show and tell.  RRRG!

ChrisB

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cadtipstricks.wordpress.com//


   

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.