Inventor General Discussion

Inventor General Discussion

New Member
Posts: 1
Registered: ‎06-16-2011
Message 1 of 3 (362 Views)

Is it possible to balloon to a sketch item?

362 Views, 2 Replies
06-16-2011 06:04 AM

I created a hatched sketch on one of my views to represent filler material.  I want to balloon to this hatched area, but it want grab it.  I have the filler material setup as a custom part.  I can also create a sketched symbol for this if that would help, but it doesn't appear that they would accept it either.


I am currently running Inventor 2010 Build 272, Release: 2010-sp3



*Expert Elite*
Posts: 870
Registered: ‎12-04-2003
Message 2 of 3 (352 Views)

Re: Is it possible to balloon to a sketch item?

06-16-2011 06:58 AM in reply to: sh03096


The only way that i know its add a baloon in a part first, then drag the arrow to the sketch edges of that virtual component.



Maria Manuela Pinho
Application Specialist
Cadtech / Asidek - Autodesk Gold Partner
Autodesk Inventor Professional 2015 | Lenovo W520
New Member
Posts: 1
Registered: ‎09-22-2011
Message 3 of 3 (312 Views)

Re: Is it possible to balloon to a sketch item?

10-11-2011 01:36 PM in reply to: sh03096

Good work around!!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.