Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
shmartin89
Posts: 74
Registered: ‎04-25-2012
Message 1 of 1 (115 Views)

iRule/Custom iProperties Bug.

115 Views, 0 Replies
12-19-2012 01:57 AM

I have iRules and Parameters set up in order to specify certain UC & UB sizes in my material list through part description.

E.g - if the parameter UC HEIGHT = '419' the parameter UC DESIGNATION = '356x406x393'

(Iv attached a snap shot of my rule browser)

 

For 27 out of 30 Beam designation sizes the rule works, my parameters update and the part description updates accordingly. For some reason certain rules dont work. When i created the rules all i did was copy the text in the rule browser and change the values accordingly.

 

Has anyone had any similar problem to this?

 

Cheers,

 

Sandy

 

Capture.PNG

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.