I'm investigating exactly into the issue reported here, but found no replies.
Did you got some additional info or workaround/solution for this issue?
Thank you in Advance
I am guessing that there is a conflict of interest between Factory 1 and Factory 2.
I get why you need to do this, but from the computer perspective, the wires are getting crossed persea.
You might want to consider just making individual parts without using the ifactory files.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!