Inventor General Discussion

Inventor General Discussion

Reply
Active Member
mirzanasrullah
Posts: 8
Registered: ‎06-13-2006
Message 1 of 2 (156 Views)

iPart Creation in Sheet Metal and Placing in Assembly.

156 Views, 1 Replies
11-28-2012 07:01 AM

Dear Autodesk Team,

 

I have created the Sheet Metal part wtih negative flange value. Ipart is creating the parts. but unable to use in assembly

 

Please guide.

 

*** Note : is it permissible to input value as NEGATIVE ***

 

Regards

 

Nasrullah Baig Mirza,
Mechanical Design Engineer,
*Expert Elite*
karthur1
Posts: 4,259
Registered: ‎04-27-2005
Message 2 of 2 (136 Views)

Re: iPart Creation in Sheet Metal and Placing in Assembly.

11-29-2012 06:36 AM in reply to: mirzanasrullah

What is the "negative flange values"?  What are you trying to accomplish with that?

 

Picture or parts would help.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.