Inventor General Discussion

Inventor General Discussion

New Member
Posts: 1
Registered: ‎11-14-2012
Message 1 of 2 (112 Views)

Inventor stoped working

112 Views, 1 Replies
11-14-2012 06:22 AM

Hello. I am using Autodesk inventor professional 2013 (student version) and whenever i press create 2D scetch or i press mouse wheel button it stops working (drops me a submit an error window). i tryed to reinstal it for many times and it started to work for a single time (when i close the program and start it again it stops working again). But afted some time reinstalling program did not helped anymore. Now I can't use my inventor. I also tryed to install updates but it didn't helped. I laptop is powerful enough to run a program. Did anybody had same problem? Please help me.

*Expert Elite*
Posts: 4,494
Registered: ‎11-13-2006
Message 2 of 2 (93 Views)

Re: Inventor stoped working

11-14-2012 04:38 PM in reply to: edgaras421

Did you follow the pre-requisites for installation:


1.) Logged in with Administrative Privileges

2.) UAC slider set to lowest position (UAC turned off)

3.) Anti-Virus software disabled.

4.) Current on all Windows sp's and hotfixes

5.) .NET 4.0 is installed on your system

6.) Your system meets the Autodesk hardware requirements (minimum specs)


The last three points are assuming Windows O/S as all you have posted is you have a laptop


You may need to do a clean install of Inventor. You can find the Clean Unistall Tool here:

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / / 4.17
Delta Tau Chi ΔΤΧ
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.