I am finally getting time to do some orginizational cleanup and management with our templates and vault settings. Many of the things are items that I am altering for each drawing/model I make and I would like to make them "stick" for the company standards. Things like altering font size in the styles library, adding part dimensions to the parameters for the parts list, and creating a new content centeral librairy where our part numbers are already populated for the parts list and the structural shapes have datum planes in the middle rather than just at begining and end.
What I would like is to know if there is an advanced book or a set of tutorials or a forum more specific for these topics that I can access rather than bothering you here with each specific issue?
Have you tried looking into the below help and you tube documentation for Inventor.
You could also visit the following blogs for some information around this topics.
Hope it helps. Do let me know, if you need more info.
Thank you for your assistance. i will be looking at this information extensively ovet the next few days.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!