I am interested in Learning about Ilogic and the Itrigger. I worked at a company where they had a prompt that would change, size, material, hole quantities etc. I am trying to recreate that for a cabinet but cannot seem to find a good tutorial, I know I need to write some sort of rule to do this but cannot find out specifcally how to do so. Would you be able to point me in the right direction or offer any expertise on the subject. I would appreciate it, Thanks for any help I appreciate it.
Have you run through the iLogic tutorials? This probably the best place to start.
iLogic - Part Modeling
iLogic - Assemblies
I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Access a broad range of knowledge to help get the most out of your products and services.