Inventor General Discussion

Reply
New Member
mattman_83
Posts: 2
Registered: ‎12-02-2006
Message 1 of 4 (98 Views)

Inventor 5 wont open!!!

98 Views, 3 Replies
12-02-2006 11:07 AM
So i recently tried to load Inventor 5 onto my home computer. The installation went fine, but now the welcome image opens (a spaceship) for a couple seconds, disappears, and then nothing else happens. any help would be great!
*Duncan Anderson
Message 2 of 4 (98 Views)

Re: Inventor 5 wont open!!!

12-04-2006 04:31 AM in reply to: mattman_83
It's a very deep sub-mersible

Inv should go to the Activation/Registration screen after the initial splash screen.

Did you disable your anti-virus when installing ?

Do you have Flash8(a) installed - remove using the utility from
http://www.adobe.com/cfusion/knowledgebase/index.cfm?id=tn_14157
And then install Flash9 http://www.adobe.com/go/getflashplayer


--
Duncan
"Humour ... is one man shouting gibberish in the face of authority, and proving by
fabricated insanity that nothing could be as mad as what passes for ordinary
living."
(Terence 'Spike' Milligan K.B.E., 1918-2002)
www.autodesk.co.uk/inventorjobs


wrote in message news:5412885@discussion.autodesk.com...
So i recently tried to load Inventor 5 onto my home computer. The installation went
fine, but now the welcome image opens (a spaceship) for a couple seconds,
disappears, and then nothing else happens. any help would be great!
*Joe Howard
Message 3 of 4 (98 Views)

Re: Inventor 5 wont open!!!

12-04-2006 05:09 AM in reply to: mattman_83
Do you have Excell on your home machine? it is required for inventor and if
just installed excell you must open excell at least once to activate it.


wrote in message news:5412885@discussion.autodesk.com...
So i recently tried to load Inventor 5 onto my home computer. The
installation went fine, but now the welcome image opens (a spaceship) for a
couple seconds, disappears, and then nothing else happens. any help would
be great!
*Gary R Smith \(Autodesk\)
Message 4 of 4 (98 Views)

Re: Inventor 5 wont open!!!

12-04-2006 06:45 AM in reply to: mattman_83
You might also make sure that your home machine has a graphics card/drivers
that supported INV5
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.