Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
smccoywm
Posts: 51
Registered: ‎09-29-2008
Message 1 of 5 (96 Views)
Accepted Solution

Inventor 2015 - Cut normal failure

96 Views, 4 Replies
06-02-2014 06:44 AM

The simple cut normal operation fails in the attached file. AutoDesk please look at.

 

Scott McCoy

 

 

Scott,

 

I just try it on Update1 to R2015. The issue is indeed resolved by Update1. Please take a look.

Many thanks!

 

Employee
johnsonshiue
Posts: 2,174
Registered: ‎04-30-2008
Message 2 of 5 (88 Views)

Re: Inventor 2015 - Cut normal failure

06-02-2014 07:09 AM in reply to: smccoywm

Hi! Could you attach the part? I don't see an attachment.

Thanks!

 



Johnson Shiue (johnson.shiue@autodesk.com)
Principal SQA Engineer, Inventor
Mechanical Design
Autodesk, Inc.

Valued Contributor
smccoywm
Posts: 51
Registered: ‎09-29-2008
Message 3 of 5 (86 Views)

Re: Inventor 2015 - Cut normal failure

06-02-2014 07:10 AM in reply to: smccoywm

Sorry here is the attachment.

Employee
david.harris
Posts: 35
Registered: ‎04-05-2007
Message 4 of 5 (82 Views)

Re: Inventor 2015 - Cut normal failure

06-02-2014 07:16 AM in reply to: smccoywm

Hi Scott,

 

We released Update 1 for Inventor 2015 on Friday.  Please install the update and let me know if this addresses the issue.

 

Best regards,

 



David Harris
Inventor Customer Response Team
Autodesk, LTD

 

Employee
johnsonshiue
Posts: 2,174
Registered: ‎04-30-2008
Message 5 of 5 (78 Views)

Re: Inventor 2015 - Cut normal failure

06-02-2014 07:28 AM in reply to: smccoywm

Scott,

 

I just try it on Update1 to R2015. The issue is indeed resolved by Update1. Please take a look.

Many thanks!

 



Johnson Shiue (johnson.shiue@autodesk.com)
Principal SQA Engineer, Inventor
Mechanical Design
Autodesk, Inc.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.