Inventor General Discussion

Inventor General Discussion

New Member
Posts: 1
Registered: ‎10-24-2012
Message 1 of 3 (3,217 Views)

Inventor 2013- Tube and Pipe Design

3217 Views, 2 Replies
10-24-2012 03:51 PM

I am a drafting instructor who has inventor 2013. Want resources (tutorial, instructional video...) explaining how to use "tube and Pipe design" with inventor 2013.

Posts: 132
Registered: ‎10-24-2008
Message 2 of 3 (3,187 Views)

Re: Inventor 2013- Tube and Pipe Design

10-25-2012 10:12 PM in reply to: gproden



I'd suggest you take a look the official tutorials first if not yet.



Nicolas Xu
Sr. SQA Eng.
Fusion 360 Quality Assurance Team
Autodesk, Inc.
*Expert Elite*
Posts: 3,305
Registered: ‎04-06-2010
Message 3 of 3 (3,173 Views)

Re: Inventor 2013- Tube and Pipe Design

10-26-2012 05:23 AM in reply to: gproden

Agree, that's the best place to start, after that I might check You Tube, lots of AD training videos out there.



Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.