Inventor General Discussion

Inventor General Discussion

Reply
New Member
JohnPeterman7845
Posts: 2
Registered: ‎07-18-2008
Message 1 of 3 (310 Views)

Inventor 2013 Shaft Generator Calculation Question

310 Views, 2 Replies
12-30-2013 09:07 AM

Hello,

 

Questions below pertain to using Autodesk Inventor 2013:

 

Can anyone tell me what factor of safety value the Shaft Generator program uses when you run the calculations?

 

Does the factor of safety value change when you are not using the inventor user material option?

 

Lastly, when exactly do you know when to use the density option in the calculation properties or not?  

Product Support
4donwan4
Posts: 169
Registered: ‎10-17-2012
Message 2 of 3 (278 Views)

Re: Inventor 2013 Shaft Generator Calculation Question

12-31-2013 11:14 AM in reply to: JohnPeterman7845

I cannot comment on this as it does not seem to be in the help files. Not sure if someone from the QA or development team can reply in here on this topic.

 

Regards,

 

Don

New Member
JohnPeterman7845
Posts: 2
Registered: ‎07-18-2008
Message 3 of 3 (243 Views)

Re: Inventor 2013 Shaft Generator Calculation Question

01-07-2014 06:48 AM in reply to: 4donwan4
Hello 4donwan4,

Thank you anyways for your help sir.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.