Inventor General Discussion

Inventor General Discussion

Posts: 16
Registered: ‎10-11-2006
Message 31 of 33 (176 Views)

Re: Inventor 2013 Failed to mesh

10-26-2012 02:02 AM in reply to: henderh

Last mont I had some problems with meshing. It turned out to be the panda virusscanner. Yesterday I did the service pack of inventor 2013. And agen no meshing. (even without panda virus scanner)


I am realy sick of these problems!

Posts: 651
Registered: ‎06-07-2007
Message 32 of 33 (154 Views)

Re: Inventor 2013 Failed to mesh

10-29-2012 10:03 AM in reply to: rschwartz

We have a similar issue reported through our product support channel, and Development has determined the cause.


I'm not sure if this is the same reason, that the meshing is not working on your machine, but it may be worth a try:


  • Create the following System Environment variables (Windows Start menu => type in search 'Environment'





It could be that UAC control on your system is preventing these environment variables to be set temporarily by Inventor.


I hope this helps, -Hugh

Hugh Henderson
Simulation QA Engineer
Active Member
Posts: 9
Registered: ‎09-01-2012
Message 33 of 33 (128 Views)

Re: Inventor 2013 Failed to mesh

11-04-2012 02:57 PM in reply to: henderh



I created the system variables that you listed.  Inventor is still failing to mesh.  Please let me know if you can think of anything else to try.



Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.