Inventor General Discussion

Inventor General Discussion

Reply
Contributor
nmetzger
Posts: 24
Registered: ‎08-24-2012
Message 1 of 5 (443 Views)

Inventor 2013, creating projection views in ipt file

443 Views, 4 Replies
12-13-2012 05:45 AM

Is it possible to create projection views of a solid model part? I want to make a front, top and right side view of the part in solid model form all on the same part file. I thought I could copy the part in each view but "help" says I can't copy a solid model... 

Distinguished Mentor
john.retzlaff
Posts: 935
Registered: ‎11-03-2003
Message 2 of 5 (434 Views)

Re: Inventor 2013, creating projection views in ipt file

12-13-2012 06:56 AM in reply to: nmetzger

If what you want is to display multiple views of a part at the same time in an ipt file, I don't think there is any way I know of to do that.  You would have to create a drawing and do it there.

 

John Retzlaff
*Expert Elite*
PaulMunford
Posts: 919
Registered: ‎11-13-2006
Message 3 of 5 (421 Views)

Re: Inventor 2013, creating projection views in ipt file

12-13-2012 01:01 PM in reply to: nmetzger
You could create a sketch and then project the surface geometry into it... but I can't see why you'd want to?
The CAD Setter Out Blog @CadSetterOut

Inventor Surfacing | AutoCAD | CAD Standards
 
Please use the Mark Solutions! Accept as Solution or Give Kudos! Kudos functions - Thank you!
*Expert Elite*
blair
Posts: 4,217
Registered: ‎11-13-2006
Message 4 of 5 (413 Views)

Re: Inventor 2013, creating projection views in ipt file

12-13-2012 10:12 PM in reply to: nmetzger

Almost sounds like you want to create a drawing with all the related views.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Delta Tau Chi ΔΤΧ
*Expert Elite*
JDMather
Posts: 27,504
Registered: ‎04-20-2006
Message 5 of 5 (283 Views)

Re: Inventor 2013, creating projection views in ipt file

09-03-2013 03:05 PM in reply to: nmetzger

Have you ever created an idw file in Inventor?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.