Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
scottmoyse
Posts: 1,700
Registered: ‎06-10-2009
Message 21 of 23 (218 Views)

Re: Inventor 2012 Mate Contraint using new (select other) pull-down feature.

07-19-2011 01:25 PM in reply to: gregmargetts8033

I think Daniela is wrong to say it will be out in a months time! The Beta hasn't even started yet, plus if you look at the historical release dates of SP1 they are predominantly late sept/ early oct. Officially its meant to be August every year, but they push it out to fix as many problems as possible, or rather to make sure they fix the curly ones that haven't been addressed with a hotfix.

Cheers
Scott Moyse

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Cheers!

Member
neil
Posts: 3
Registered: ‎05-22-2003
Message 22 of 23 (185 Views)

Re: Inventor 2012 Mate Contraint using new (select other) pull-down feature.

07-26-2011 10:03 AM in reply to: cwymth

I really hope they fix this soon, the problem with applying constraints (or to be precise, NOT applying them) is very frustrating.

Active Contributor
charlesww
Posts: 29
Registered: ‎09-16-2005
Message 23 of 23 (135 Views)

Re: Inventor 2012 Mate Contraint using new (select other) pull-down feature.

08-26-2011 05:29 AM in reply to: johnsonshiue

This "New and improved" select other makes assembly angle constraints almost impossible. We need a fix soon. 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.