Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
varindersra
Posts: 252
Registered: ‎09-28-2009
Message 1 of 2 (213 Views)

Inventor 2012-Drawing Break View

213 Views, 1 Replies
05-02-2012 09:10 AM

Hi,

 

In the Drawing mode. I have some of the lines I override with a different layer rather than default layer. When I place a break view in my drawing it automatically changes the layer to default again. How to resolve this issue to stop auto switching.

 

Thanks in advance!

 

Varinder

Product Support
dave.anderson
Posts: 193
Registered: ‎10-25-2006
Message 2 of 2 (177 Views)

Re: Inventor 2012-Drawing Break View

05-15-2012 06:58 AM in reply to: varindersra

I've tested both changing an edge properties, and reassigning it to another layer without seeing the issue you''ve described. I inserted new views, made broken views & break out views of it as well as the view with the modified edges and they are retained. With and Without the Enable Background updates enabled.

 

I'm out of ideas to test. Would it be possible to post an example file?

 

I tested in 2012 SP1.



Dave Anderson
Premium Support Analyst – DLS Mechanical Design
Autodesk, Inc.


If I have answered your question, please "Accept Solution" so others may benefit as well.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.