Inventor General Discussion

Inventor General Discussion

Reply
Contributor
none1
Posts: 16
Registered: ‎03-30-2012
Message 21 of 24 (153 Views)

Re: inventor 2011 will not give me an angle dim

11-30-2012 10:53 AM in reply to: nannerdw

I disagree not all posts had the intent of answering the question.  I see some of the insulting posts are now gone from this thread.

 

The correct answer would have been "no you cannot tell inventor angular not linear".

 

I did figure out the problem myself.  IT IS A BUG WITH INVENTOR conflicting with other softwares and MS.

 

 

 

 

Contributor
none1
Posts: 16
Registered: ‎03-30-2012
Message 22 of 24 (148 Views)

Re: inventor 2011 will not give me an angle dim

11-30-2012 11:02 AM in reply to: nannerdw

Yes the sketches were from the same view  (I believe that terminology "viewport" is for ACAD only) or the BASE VIEW in inventor.  

 

Inventor refused to see any lines from a different sketch.  So when I clicked on the 2nd line it automatically through out linear dims for the 1st line i selected.  ONCE I placed both liines in the same sketch all was good.

 

*Pro
ampster
Posts: 1,386
Registered: ‎07-26-2005
Message 23 of 24 (122 Views)

Re: inventor 2011 will not give me an angle dim

11-30-2012 12:21 PM in reply to: none1

pebkac

 

going by all posts.

 

Good Luck in your future.

Contributor
none1
Posts: 16
Registered: ‎03-30-2012
Message 24 of 24 (80 Views)

Re: inventor 2011 will not give me an angle dim

12-19-2012 08:09 PM in reply to: ampster

pebkac   Is this English?

 

going by all posts.     Going by proper English all sentences are to start with a Capital letter.  Didn't you learn this in grade school? 

 

Good Luck in your future.

 

Is this kindness or a threat?

 

Well I will answer to both.

 

Kindness    Thanks and Happy Holidays!

 

Threat  Well I do not believe in LUCK I believe in FATE.  Threats are illogical!   SPOCK  Star Trek

 

Happy Holidays!

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.