Inventor General Discussion

Inventor General Discussion

Reply
New Member
raumechanicaljoe
Posts: 2
Registered: ‎07-10-2012
Message 1 of 2 (114 Views)
Accepted Solution

Inventor 2011 not Running When Double Clicked

114 Views, 1 Replies
10-01-2012 01:56 PM

I just installed the student verion of Inventor 2011 on my machine. Everyhting went well but when I double click the inventor icon nothing happens. Autocad mechanical and TruView work fine. Anyone have any suggestions? 

 

Thanks!

What are your system specs?

Did you have ant-virus and UAC turned off during install.

*Expert Elite*
JDMather
Posts: 27,474
Registered: ‎04-20-2006
Message 2 of 2 (112 Views)

Re: Inventor 2011 not Running When Double Clicked

10-01-2012 02:05 PM in reply to: raumechanicaljoe

What are your system specs?

Did you have ant-virus and UAC turned off during install.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.