Inventor General Discussion

Inventor General Discussion

Reply
New Member
jedpalmer
Posts: 1
Registered: ‎08-01-2007
Message 1 of 1 (117 Views)

Inventor 2010 crash when creating projected view

117 Views, 0 Replies
04-02-2012 12:43 PM

Inventor 2010, SP 4, running on Windows XP 32-bit SP3.

 

I'm having problems creating any projected views from a relatively large assembly (856 parts, 124 files). I can create a base view no problem, but cannot create a projected view even with hidden lines, threads, and reference parts off. Creating a projected view results in Inventor crashing.

 

The only thing I can think of is that we are using quite a few substitute levels of detail for some of the smaller assemblies within the large one. Those have been somewhat difficult to work with.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.