Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Inventor 2009 Thread Display.

2 REPLIES 2
Reply
Message 1 of 3
Craigflo
235 Views, 2 Replies

Inventor 2009 Thread Display.

Hi,

I was wondering if anyone had a soultion to the problem I have.

If I draw a cube 100 x 100 x 100, then I chamfer one of the edges, I then create a threaded hole (thru all) on the chamferd edge.

When I come to create a drawing of the above, the thread on the hole will only display on the side elevation.
When I create an end elevation I have no thread form shown.

I have attached a file to highlight what the problem is.

Hopefully someone can help
2 REPLIES 2
Message 2 of 3
mcgyvr
in reply to: Craigflo

Looks like a bug..Does it in 2010 also. (might be a drafting standard to display like that but I doubt it)


-------------------------------------------------------------------------------------------
Inventor 2023 - Dell Precision 5570

Did you find this reply helpful ? If so please use the Accept Solution button below.
Maybe buy me a beer through Venmo @mcgyvr1269
Message 3 of 3
UnTone
in reply to: Craigflo

Thank you for raising this question. It is most likely a bug/limitation. The issue has been reported to the Inventor development team. I will let you know if there is some workaround.


Anton Fedoseyev
Education Solutions Specialist
Education EMEA
Autodesk, Inc.


http://inventor-ru.typepad.com/

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report