Inventor General Discussion

Inventor General Discussion

Active Contributor
Posts: 36
Registered: ‎06-26-2003
Message 1 of 1 (29 Views)

INV BOM to Excel - error message

29 Views, 0 Replies
11-11-2002 01:06 AM
Hi all, this post is a result inthe post labled: Mass Move & part relinking:

When I tried to export my BOM from INV to Excell I get the following error message: "Coundn't set value - Item not found" What does that mean?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.