Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
janlsing
Posts: 38
Registered: ‎09-28-2007
Message 1 of 1 (179 Views)

Interchange sketch of extrusion

179 Views, 0 Replies
10-27-2013 11:27 AM

I'am using the derived "skelleton-1.ipt" in the file "solid-1.ipt".

The "skelleton-1.ipt" contains the sketch "sketch-A".

The "solid-1.ipt" contains the feature "extrusion-A" based on "sketch-A" of "skelleton-1.ipt"

When I make a saveas copy of "skelleton-1.ipt" to "skelleton-2.ipt",

how is it possible to interchange the "sketch-A" of "skelleton-1.ipt" by "sketch-A" of "skelleton-2.ipt" without making a mess of "extrusion-A"? So interchanging the sketch on which an extrusion is based.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.