Inventor General Discussion

Inventor General Discussion

Reply
Contributor
sinus19
Posts: 25
Registered: ‎08-24-2012
Message 1 of 2 (145 Views)

Increasing Hydraulic hose size beyond standard 2" (max)

145 Views, 1 Replies
02-01-2013 10:26 AM

How can i increase the size of the hose beyond 2" max that Pipe&Run allows it to be? I need the hose more for a visual rather then its acual function. I'm guessing i gonna have to change its paremeters right? if so, how do i and what needs changed?

Thnks!

*Expert Elite*
blair
Posts: 4,230
Registered: ‎11-13-2006
Message 2 of 2 (137 Views)

Re: Increasing Hydraulic hose size beyond standard 2" (max)

02-01-2013 01:50 PM in reply to: sinus19

Sounds like you are using the standard Parker library that ships with Inventor. You would need to create your own Library with the larger sizes. The easiest is to just copy the Read-Only Parker CC library, make your edits and import it into your own Read-Write MyLibrary.

 

The first time or two around it's easier to copy and make your edits rather than start from scratch. There is a pretty good Tube & Pipe PDF in the Autodesk Inventor Help directory. You will need to search around a bit, depending on system install to find it.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Delta Tau Chi ΔΤΧ
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.