Inventor General Discussion

Inventor General Discussion

Reply
New Member
bkanen822
Posts: 2
Registered: ‎02-14-2013
Message 1 of 3 (272 Views)
Accepted Solution

Incomplete Section View

272 Views, 2 Replies
02-14-2013 09:03 AM

I am trying to produce a section view of a vessel. Inventor makes the section just fine except it is incomplete. See images below:

 

Section View.jpg

Section View 2.jpg

 

In the past when I have encountered this issue I would simply locate the part in the browser, Right click on it + Section Participation + section. That ususally solves the issue. This time it is not working.

 

menue.jpg

 

Any suggestiongs would be greatly appreciated.

 

Thank you

You have to do this in the right place.  You have to set the option in the parts under the actual section view.  See below.

 

Section Parts.png

 

It's impossible to tell from the images you supplied if you are doing it in the right place, so check to make sure this isn't the problem.  Also, you can't do it in a view underneath the section view, such as another section, or a detail view.

 

-cwhetten

Please click "Accept as Solution" if this response answers your question.

*Expert Elite*
cwhetten
Posts: 1,089
Registered: ‎09-03-2008
Message 2 of 3 (250 Views)

Re: Incomplete Section View

02-14-2013 09:34 AM in reply to: bkanen822

You have to do this in the right place.  You have to set the option in the parts under the actual section view.  See below.

 

Section Parts.png

 

It's impossible to tell from the images you supplied if you are doing it in the right place, so check to make sure this isn't the problem.  Also, you can't do it in a view underneath the section view, such as another section, or a detail view.

 

-cwhetten

Please click "Accept as Solution" if this response answers your question.

New Member
bkanen822
Posts: 2
Registered: ‎02-14-2013
Message 3 of 3 (240 Views)

Re: Incomplete Section View

02-14-2013 09:57 AM in reply to: cwhetten

That was my problem. I was pretty sure I checked that but I guess not.

 

Thank you for your prompt reply!

 

Section View 3.jpg

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!