Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Importing Inventor Design Accelerator Components into Showcase

1 REPLY 1
Reply
Message 1 of 2
cellt2
574 Views, 1 Reply

Importing Inventor Design Accelerator Components into Showcase

Hi,

I have a hybrid issue here. 

 

When I import an Inventor model to Showcase, bolted connections are missing the bolt.  I get the washers and nuts but the bolt is gone.  I can overcome this by saving the bolt part in a project folder but this is time consuming. 

 

Are there some settings I am missing or is it just another item to add to the fixit list?

1 REPLY 1
Message 2 of 2
blair
in reply to: cellt2

Make sure that you selected the correct Project file from Inventor that your IAM was created under. This will allow Showcase to find the directories for all the parts.

 

Also make sure that you are current on all Showcase SP's. SP4 or even R1 (after SP4).

 

Since you didn't post your version release I am assuming 2013


Inventor 2020, In-Cad, Simulation Mechanical

Just insert the picture rather than attaching it as a file
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Delta Tau Chi ΔΤΧ

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report