Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
cellt2
Posts: 40
Registered: ‎12-01-2010
Message 1 of 2 (319 Views)

Importing Inventor Design Accelerator Components into Showcase

319 Views, 1 Replies
02-03-2013 08:56 PM

Hi,

I have a hybrid issue here. 

 

When I import an Inventor model to Showcase, bolted connections are missing the bolt.  I get the washers and nuts but the bolt is gone.  I can overcome this by saving the bolt part in a project folder but this is time consuming. 

 

Are there some settings I am missing or is it just another item to add to the fixit list?

*Expert Elite*
blair
Posts: 4,491
Registered: ‎11-13-2006
Message 2 of 2 (310 Views)

Re: Importing Inventor Design Accelerator Components into Showcase

02-03-2013 11:48 PM in reply to: cellt2

Make sure that you selected the correct Project file from Inventor that your IAM was created under. This will allow Showcase to find the directories for all the parts.

 

Also make sure that you are current on all Showcase SP's. SP4 or even R1 (after SP4).

 

Since you didn't post your version release I am assuming 2013

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / 17.2.0.11011 / 4.17
Delta Tau Chi ΔΤΧ
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.