Inventor General Discussion

Inventor General Discussion

Reply
New Member
red1
Posts: 1
Registered: ‎02-03-2003
Message 1 of 2 (69 Views)

iMates & invisibility

69 Views, 1 Replies
11-29-2002 06:51 PM
Hello, All.

I have a little question about iMates.
Can i hide iMates signs in Inventor's 5.3 assembly file?
Is it possible or not?

--
Best regards,
Dmitry mailto:kostikov@vstu.ru
*Maas, Karl
Message 2 of 2 (69 Views)

Re: iMates & invisibility

12-01-2002 09:47 PM in reply to: red1
they disappear when you use them to constrain to
your assembly. Other wise, I think you have to go into the original part and
turn off iMate glyphs in the View pull-down.


--
K

 

 


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
Hello,
All.

I have a little question about iMates.
Can i hide iMates signs in
Inventor's 5.3 assembly file?
Is it possible or not?

--
Best regards,
 Dmitry
mailto:kostikov@vstu.ru

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.