Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
LewisLusby
Posts: 29
Registered: ‎08-13-2012
Message 1 of 2 (187 Views)

iLogic to override density

187 Views, 1 Replies
01-14-2013 04:27 PM

Hi all.

 

Bit of a tricky one (for me anyway!). I'm driving an Inventor GA using iLogic, within this GA are various guard sub-assemblies..........(See example attached). I designed it so that if the material for the sub assemblies is changed then the sheet thickness is also changed (eg, if alu = 3mm sht, mld stl = 2mm). Look at the attached, the grey parts are, in reality, meshed. However i do not want to create the meshed profiles so can i override the density (x0.7) using iLogic. I could override the mass by adding (0.7 x mass) BUT this does not update if the geometry changes (also driven by the GA.

 

I hope this makes SOME sense,

 

Regards,

Lewis

Active Contributor
LewisLusby
Posts: 29
Registered: ‎08-13-2012
Message 2 of 2 (157 Views)

Re: iLogic to override density

01-20-2013 04:47 PM in reply to: LewisLusby

Anyone???:manfrustrated:

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.