Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Ilogic code to set parameter filter

1 REPLY 1
Reply
Message 1 of 2
Skwiggle
222 Views, 1 Reply

Ilogic code to set parameter filter

I have noticed that if I set the parameter filter list to only show key parameters and then save the model, when I open the same model on another PC the parameter list shows all parameters, not just the key ones. Is there any ilogic code that will control the selection status of the parameter filter?. I hope this makes sense and any help or comments will be greatly appreciated.
1 REPLY 1
Message 2 of 2
mrattray
in reply to: Skwiggle

The parameter filter state isn't a part specific setting, it's an Inventor setting. If you change the setting on the other PC it should stay that way for all files.
Mike (not Matt) Rattray

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report